• Provides rapid and efficient troubleshooting of wiring faults in your cabling
  • The built-in tone generator helps you to identify individual wires (Cable Tracker CT15 available as an option)
Datasheet
Quick start manual
the poduct overview of the cablemaster 600 Cable Tester Overview

How do I activate the sound generator of my CableMaster 200?

Hold down the universal-button of the CableMaster 200 and release when you see the indicator (Hi Lo 1, 2 Hi Lo, Hi, Lo).

I activated the sound generator of my CableMaster 200, but I can't hear anything. How can I track the tone?

The sound can be received with a tone probe (accessory unit). You will need our CT15 Probe (article no. 226007).

I've supplied the cable with a sound and now I´m looking for the cable with a tone probe. However, I do not hear anything when I put the probes on the cable sheath.

You are probably using a shielded/laminated cable. The shielding is used for electromagnetic shielding of the cable, so the signal of the sound generator is shielded. However, you can still receive the tone at the open ends or sockets/plugs on the cable with the probes.

How do I get to the endurance test?

Hold down the universal-button of the CableMaster 200 and release when you see the indication "LOOP".

What do lashing minus signs mean in the wiring diagram?

This display means that the flashing wires are shorted.

There is a "U" shown in the wiring diagram, what does that mean?

The display stands for "Unknown" and refers to an unknown wiring error. This can happen, for example, if the affected wires are shorted with another cable.

The operating language of my CableMaster 200 is English. Can I change this?

There is no alternative language other than English for the CableMaster 200 available.

My CableMaster 200 shows "Split". What does that mean?

A "split pair" - error is a rare cabling error. It occurs when an identical mistake was made at the assembly on both sides of a cabling link. The white veins of two identical pairs are reversed at both ends, although the consistent the orientation of the wires causes a very high crosstalk The result: A communication of active components is not possible.